Zenith Chassis Cabinet 'Washers"

1/25/2009 11:12:04 AMBob E.

Does anyone know of a source for the 1 1/2 inch diameter
"spongy" washers used in these cabinets? I am looking
for one for a 6S222.
Or what the thickness of these original washers were?
Bob

1/25/2009 1:16:51 PMJohnny

:Does anyone know of a source for the 1 1/2 inch diameter
:"spongy" washers used in these cabinets? I am looking
:for one for a 6S222.
:Or what the thickness of these original washers were?
:Bob
:
:Hi Bob, You can try "renovatedradios.com". They have a selection of repro parts like that but I don't know if they have that one. I just finished a 6S223 and mine were about 3/8" thick by 1-1/4" in diameter. I just substituted them with rubber washers that I found at my local Ace hardware. Worked fine. Johnny.

1/25/2009 3:19:35 PMTerry F

Check this link:

http://www.alanjesperson.com/gn_repro.htm#Rubber%20Donut%20Chassis%20Cushions

Good luck
Terry F

1/25/2009 6:34:26 PMThanks, Bob E.

Thanks.
I will contact them aboubt those washers.
Bob

: :http://www.alanjesperson.com/gn_repro.htm#Rubber%20Donut%20Chassis%20Cushions
:
:Good luck
:Terry F

1/25/2009 8:19:57 PMRobert H.

:Check this link:
:
:http://www.alanjesperson.com/gn_repro.htm#Rubber%20Donut%20Chassis%20Cushions
:
:Good luck
:Terry F

Radio Daze also carries the washers. I have used them on two Zenith consoles. http://www.radiodaze.com/

1/26/2009 9:31:17 PMBob E.

I think I have even ordered them from RD before...
Don't know how I forgot about them carrying washers
like that. I suppose it would be the 3/8 in thick
ones (Part # CW187) for the Zenith 6S222....
Thanks Robert.

:Radio Daze also carries the washers. I have used them on two Zenith consoles. http://www.radiodaze.com/