What do I use to pour a mold?

1/10/2003 12:39:03 AMBrad Winder

Hi All,
I need to reproduce the small leg for the bottom of my Philco 37-3670. It is too intricate to turn on a lathe, so I made a mold from an existing leg. What is a good material to pour in the mold to make the leg out of? It should probably be strong, but still sand and be able to take a stain. Thanks!
Brad

1/10/2003 12:34:05 PMNorm Leal

Hi Brad

Check with a local store selling plastic. TAP has the material in our area and might be found on the internet.

Norm

:Hi All,
:I need to reproduce the small leg for the bottom of my Philco 37-3670. It is too intricate to turn on a lathe, so I made a mold from an existing leg. What is a good material to pour in the mold to make the leg out of? It should probably be strong, but still sand and be able to take a stain. Thanks!
:Brad

1/10/2003 5:00:49 PMJody Jensen

:Hi All,
:I need to reproduce the small leg for the bottom of my Philco 37-3670. It is too intricate to turn on a lathe, so I made a mold from an existing leg. What is a good material to pour in the mold to make the leg out of? It should probably be strong, but still sand and be able to take a stain. Thanks!
:Brad