I feel like an absolute idiot! The dial cord on this Zenith is not at all complicated, yet I can't seem to get it strung right. It will tune Up the dial fine, but stop about half way down, as the cord laps over itself the wrong way on the shaft where it wraps around twice. I've done these a million times. What the heck am I doing wrong? Could use a dial cord diagram for this one, but can't find one.

Hi,
Does the knob and dial turn the same direction? You may need to change the direction of how the string winds on that one shaft.

Go to the Rider's section of this site, and find your chassis number, when the first image starts to load, click on the image for the larger image. Edt the address as it appears in your location window for the next page say you have zen12-33.gif, change it to zen12-34.gif, and so on until you hit the next model. I believe there is a stringing diagram for this one.

:I feel like an absolute idiot! The dial cord on this Zenith is not at all complicated, yet I can't seem to get it strung right. It will tune Up the dial fine, but stop about half way down, as the cord laps over itself the wrong way on the shaft where it wraps around twice. I've done these a million times. What the heck am I doing wrong? Could use a dial cord diagram for this one, but can't find one.