I have a nice Zenith table model radio model #7H802UZ that I could use an assist on for a repair. I turned the knob for tuning and things did not cooperate.... I found the "string/lightwieght cord" used to connect the knob to the radio dial was deteriorated and not in place. There are small wire springs on the two round "pulley" sorta pieces, but I do not know how to "thread the string for proper operation. I figure I can use some heavy duty carpet thread cord, but would like to know how to wind that. Any help out there? Thanks! John

:I have a nice Zenith table model radio model #7H802UZ that I could use an assist on for a repair. I turned the knob for tuning and things did not cooperate.... I found the "string/lightwieght cord" used to connect the knob to the radio dial was deteriorated and not in place. There are small wire springs on the two round "pulley" sorta pieces, but I do not know how to "thread the string for proper operation. I figure I can use some heavy duty carpet thread cord, but would like to know how to wind that. Any help out there? Thanks! John
:
John,
Could the model be 7H820, chassis 7E01?
If so, I can email you with the diagram.
Carl T

Hi John,
Do you mean 7H820?
These have the dial in the center of the speaker.

Best Regards,

Bill Grimm