Hi,

I'm trying to figure out how to arrange the drive cord on a Marconi #75.

My documents doesn't show the arrangement of the drive cord.

It has 2 small flat pulley about same size (1/2" diameter)
One on the tuning capacitor shaft, and one on the dial pointer shaft. I don't see any place to install a spring.

The pulley on the tuning capacitor shaft has 2 slots across the top.

The pulley above, on the dial pointer shaft, has a hole through it.

I suppose the cord should pass through that hole, but i dont understand how to fix the cord at the bottom.

Any idea ?

Thanks
Vianney

Never mind.

I finally found a way to arrange the drive cord.
:o)