Type | Substitutes | Base Diagram |
---|---|---|
6BK7B | 6FW8, 6KN8, 6AQ8, 6BC8*, 6BQ7*, 6BZ7*, 6BZ8*, 6CH7, 6CX7, 6BK7A, 6BK7, 6BQ7A*, 6BS8*, 6BX8*, 6HK8*, X155* | |
Notes: | * - Parallel filaments | |
Web References | 6BK7B (RCA (HB3)) @ Franks Electron Tubes 6BK7B (General Electric) @ Franks Electron Tubes 6BK7B (Tung-Sol) @ Franks Electron Tubes 6BK7B (RCA (RC30)) @ Franks Electron Tubes 6BK7B @ RadioMuseum.org |
Bulb | T-61/2 |
Base | Miniature Button 9-Pin |
Basing | 9AJ |
Mounting Position | Any |
Heater Voltage (AC/DC) | 6.3 | Volts |
Heater Current | 450 | Ma |
Heater Warm-Up Time (Avg) | 11 | Seconds |
Grid to Plate | 1.8 | 1.8 | ��f |
Grid to Cathode, Heater, and Internal Shield | 3 | 3 | ��f |
Plate to Cathode, Heater, and Internal Shield | 1 | 0.9 | ��f |
Cathode to Grid, Heater, and Internal Shield | 6 | 6 | ��f |
Plate to Grid, Heater, and Internal Shield | 2.4 | 2.4 | ��f |
Plate to Cathode | 0.22 | 0.22 | ��f |
Heater to Cathode | 2.8 | 3 | ��f |
Grid of Unit 1 to Grid of Unit 2 | - | 0.004 | max ��f |
Plate of Unit 1 to Plate of Unit 2 | - | 0.075 | max ��f |
Plate Voltage | 300 | Volts |
Grid Voltage, Negative-Bias value | -50 | Volts |
Plate Dissipation | 2.7 | Watts |
Peak Heater-Cathode Voltage (neg to cathode) | 2001 | Volts |
Peak Heater-Cathode Voltage (pos to cathode) | 2002 | Volts |
Plate Supply Voltage | 150 | Volts |
Cathode-Bias Resistor | 56 | Ohms |
Amplification Factor | 43 | X |
Plate Resistance | 4600 | Ohms |
Transconductance | 9300 | �mhos |
Plate Current | 18 | Ma |
Grid Voltage for Plate Current of 10 �a | -11 | Volts |
1 | In cathode-drive circuits with direct-coupled drive, it is permissible for this voltage to be as high as 300 volts under cutoff conditions. |
2 | The dc component must not exceed 100 volts. |