Home  Resources  References  Tubes  Forums  Links  Support  Sale  Search 



   < Previous Message Index Next Message >   


Antique Radio Technical Forum
Thorens CD43 Turntable

Posted by MAG on 05/04/2007 11:43

:Hello All,
: I hope that this isn't off topic. This turntable is fine, only the power cord pulled out and I'm not sure where it goes. It's in SAMs 222-15. I think it connected through the motor and I'm going to have to open the case of the motor to replace it.
:
:This is a fantastic turnable. It had better speed ratings of many broadcast turntables of the time. I haven't taken the platter off. I thought it was direct drive but lately it has been a little sluggish when cycling. So it probably has warn rubber parts. I have a suppler/rebuilder for those.
: Replacing the power cord is my main concern. So if someone has a picture of where it connects. It would help.
:
:Thanks,
:
:Dave

Hi Dave,
I don't think that the Sams will help you with the motor connections, it only shows the mechanical layout, no wiring at all.

It does state that to lubricate the motor: "Remove the turntable and introduce a few drops of good quality thin oil (sae 20) into the lubricating holes (colored red)."

Meade


Thorens CD43 Turntable 
Dave Froehlich 05/03/2007 15:56 
MAG 05/04/2007 11:43 
Dave Froehlich 05/04/2007 23:52 
MAG 05/06/2007 22:47 
Dave Froehlich 05/10/2007 20:28 
Thomas Dermody 05/04/2007 23:54 
Fred R 05/05/2007 09:18 
Dave Froehlich 05/10/2007 20:26 
Fred R 05/10/2007 22:02 
Dave Froehlich 05/10/2007 22:19 
Dave Froehlich 03/03/2012 13:07 

   < Previous Message Index Next Message >   




© 1996-2004 Nostalgia Air