| ::On broadcast band the !R5 is fine. Make sure you have good continuity in your wavemagnet. Being a tuned circuit the BC band needs that to be working. Remember also the wavemagnet will null signals if not turned correctly. Rotate the wavemagnet or the entire radio for best reception. I thought mine was dead also on part of the band until I started rotating the radio. : : :Thanks Joe and everyone I'll try to get a better look at the contacts and recheck the wavemagnet. :I'll post again any follow up. : :thanks to all :JIM Does that model have a selenium rectifier? My T/O (L series) would work on some BC stations and fade out completely on others after a minute or two. The voltages were a little low after a check. The SW seemed to work fine at that time also. I changed the rectifier with a diode and dropping resistor and it works fine now. Could that be your problem? |
| zenith t.o. h-500 bcb sia switch | |
 jim | |
  Doug Criner | |
 Walt | |
| Lewis L | |
| jim | |
| jim | |
| Doug Criner | |
| Joe | |
| JIM | |
| SteveB | |
| Bill G. | |
| Radiodoc | |
| Joe |
| < Previous Message | Index |