Home  Resources  References  Tubes  Forums  Links  Support  Sale  Search 



    Index Next Message >   


Antique Radio Technical Forum
zenith t.o. h-500 bcb sia switch

Posted by jim on 07/02/2009 16:58

Hi guys I need some help on this problem.
First I'm not that knowledgeable and pretty frustrated.
the problem is that when I press the bcb switch part way in there is reception and when it's all the way in the signal strength drops significantly especially from 800 to 550kc.note I am using a 1r5 in place of 1l6.
Also the sets been recapped and I gave the switch assy a good clean and sprayed with deoxit.
I was looking at the schematic fig 16 of the military manual which shows the bcb circuit but don't know what the box symbol is as opposed to that other polygonal one.
I don't have a 1l6 so I'm not sure if this is due to the 1r5, if it is this issue may be mute.
Any advice?


many thanks JIM


zenith t.o. h-500 bcb sia switch 
jim 07/02/2009 16:58 
Doug Criner 07/02/2009 17:39 
Walt 07/02/2009 18:00 
Lewis L 07/02/2009 18:05 
jim 07/02/2009 20:43 
jim 07/02/2009 20:55 
Doug Criner 07/05/2009 16:17 
Joe 07/02/2009 18:28 
JIM 07/02/2009 21:04 
SteveB 07/06/2009 08:27 
Bill G. 07/06/2009 08:59 
Radiodoc 07/07/2009 16:44 
Joe 07/07/2009 17:20 

    Index Next Message >   




© 1996-2004 Nostalgia Air