| :Hi all I am restoring a Philco 52. It has a block of caps (Philco part # 03915 cap values are .1,.5,.25,.5,.15 )The wires comming out of the block are usually color coded making the job easy. In this case the wires are coded in tar and I can't make out color on wires. Plus the schematic does not give values..just the placement of caps by virtue of a number(23 on schematic) My question is..could I just replace all with .5 values or will this effect preformance?? Unless you are an engineer, I would trust the original engineer(s) of the radio and replace with correct values. I would think if a single values was acceptable, they would have used it then. You know there is a Philco Forum on the net? Syl |
| Philco 52 restoration..cap block question | |
 G. Berg | |
  Bill G. | |
 G. BerG Thanks Bill | |
| Lewis L | |
| G. Berg | |
| Thomas Dermody | |
| G. Berg ok thanks | |
| Z- | |
| Z- | |
| G. Berg | |
| Norm Leal | |
| G. Berg |
| < Previous Message | Index | Next Message > |